- Home
- Move Water
- Sta-Rite
- Sta-Rite Products
- Sta-Rite Water Supply Pumps
- Sta-Rite Jet Pumps
- Pentair Sta-Rite PL Series Thermoplastic Convertible Deep Well Jet Pumps
Pentair Sta-Rite PL Series Thermoplastic Convertible Deep Well Jet Pumps
Main Content Starts Here
Pentair Sta-Rite PL Series Thermoplastic Convertible Deep Well Jet Pumps
The performance-proven PL Series is constructed to be lightweight and extremely resistant to sand and abrasive wear, it performs best on all deep well installations.
Key Features
- Superior Rustproof Construction - Pump body is Dura-Glas fiberglass reinforced thermoplastic - lightweight, rustproof and exceptionally strong. All components in contact with water are resistant to the corrosive and abrasive forces found in the most aggressive water conditions.
- Heavy-duty Motor - Dustproof canopy completely encloses electrical components and provides dust, dirt and insect protection. Ventilating air cannot contaminate vital switching components. Permanently lubricated, heavy-duty ball bearings ensure smooth, quiet operation and extended motor life.
- Precision Diffuser - Multi-port, reinforced polypropylene design primes faster and handles more air.
- Precision Molded Impeller - Precision molded Noryl® gives perfect balance and ultra-smoothness for highest performance and efficiency.
Warranty
1 year limited warranty
Performance Curve
Specifications
Item # | Horsepower |
---|---|
PLC | 1/2 |
PLD | 3/4 |
PLE | 1 |
PLF | 1-1/2 |
Item # | Horsepower |
---|---|
PLC | 1/2 |
PLD | 3/4 |
PLE | 1 |
PLF | 1-1/2 |
BODY CONSTRUCTION: Thermoplastic
MAXIMUM CAPACITY: 26.3 GPM (Model PLE with Shallow Well Setup)
FLOW at 10' LIFT and 40 PSI: 13.8 GPM (Model PLD Shallow Well Setup)
MAX LIFT: 25' w/ Shallow Well jet Kit / 60' w/ Deep Well Jet Kit
MAX SHUT-OFF PRESSURE: 72 PSI (model PLC in shallow well config)
MAXIMUM TOTAL PRESSURE (Inlet + Pump Pressure): PLC: 72 PSI / PLD:62 PSI / PLE: 62 PSI / PLF: 64 PSI
PRESSURE SWITCH SETTING: 30-50 PSI
SUCTION SIZE: 1-1/4" NPR
DRIVE SIZE: 1" NPT (suction-over-drive)
DISCHARGE SIZE: 1" NPT
AMP DRAW (full load): 6.1 amps on 230v / 12.2 amps on 115v
VOLTAGE: 115v/230v AC, 60 Hz, 1-phase
MAXIMUM LIQUID TEMPERATURE: 140 F (60 C)
Noryl® is a registered trademark of SABIC Innovative Plastics IP BV